| 名前 | 解説 | |
|---|---|---|
 | AddArc | Adds a single arc to the path geometry. |
| AddBezier | Creates a cubic Bezier curve between the current point and the specified endpoint. |
| AddBeziers | Creates a sequence of cubic Bezier curves and adds them to the geometry sink. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |
| AddLine | Creates a line segment between the current point and the specified end point and adds it to the geometry sink. |
| AddLines | Creates a sequence of lines using the specified points and adds them to the geometry sink. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |
| AddQuadraticBezier | Creates a quadratic Bezier curve between the current point and the specified endpoint. |
| AddQuadraticBeziers | Adds a sequence of quadratic Bezier segments as an array in a single call. |
| BeginFigure | Starts a new figure at the specified point. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |
| Close | Closes the geometry sink, indicates whether it is in an error state, and resets the sink's error state. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |
| Dispose | System.IDisposableから継承されます。 |
| EndFigure | Ends the current figure; optionally, closes it. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |
| SetFillMode | Specifies the method used to determine which points are inside the geometry described by this geometry sink and which points are outside. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |
| SetSegmentFlags | Specifies stroke and join options to be applied to new segments added to the geometry sink. C1.Util.DX.Direct2D.SimplifiedGeometrySinkから継承されます。 |