Outline(Single,IGeometrySink) メソッド

Computes the outline of the geometry and writes the result to an ISimplifiedGeometrySink.

シンタックス

Visual Basic
C#

'宣言
 
Public Overloads Sub Outline( _
   ByVal flatteningTolerance As System.Single, _
   ByVal geometrySink As IGeometrySink _
)

public void Outline( 
   System.float flatteningTolerance,
   IGeometrySink geometrySink
)

パラメータ

flatteningTolerance: The maximum bounds on the distance between points in the polygonal approximation of the geometry. Smaller values produce more accurate results but cause slower execution.
geometrySink: The ISimplifiedGeometrySink to which the geometry's transformed outline is appended.

戻り値の型

If the method succeeds, it returns S_OK. Otherwise, it returns an HRESULT error code.

解説

The {{Outline}} method allows the caller to produce a geometry with an equivalent fill to the input geometry, with the following additional properties: The output geometry contains no transverse intersections; that is, segments may touch, but they never cross.The outermost figures in the output geometry are all oriented counterclockwise. The output geometry is fill-mode invariant; that is, the fill of the geometry does not depend on the choice of the fill mode. For more information about the fill mode, see FillMode.Additionally, the {{Outline}} method can be useful in removing redundant portions of said geometries to simplify complex geometries. It can also be useful in combination with GeometryGroup to create unions among several geometries simultaneously.

参照

Geometry クラス
 Geometry メンバ
 オーバーロード一覧